Copyright © Cloud Software Group, Inc. All rights reserved.
Copyright © Cloud Software Group, Inc. All rights reserved.


Chapter 14 Managing EAI Step Server Plug-ins : Unregister (Remove) an EAI Plug-In

Unregister (Remove) an EAI Plug-In
Use the UNREG command to remove an EAI step type entry from the plug-in registry. This results in the EAI step type being unregistered from the server so the server will not be able to process any EAI steps that use this server plug-in.
Syntax
sweaireg UNREG eai_type_name [-m machine_name] [-y]
where:
eai_type_name is the short name of the EAI step type handled by the plug-in. This can be a text string up to 20 characters.
machine_name is the optional name of the server in the TIBCO iProcess Engine node cluster on which the plug-in is registered. If this value is omitted, the default is the server on which the command is being run. This can be a text string up to 256 characters.
-y can be used to automatically answer yes to all the sweaireg command prompts so the command is run immediately without displaying the prompts.
After running the command, the following prompt is displayed:

 
Unregister EAI Run-Time Plug-In
EAI Type EAI Type Name
Machine machine name ID:xx
Version Release Version
Library: library path and name
Init Params: Initialisation parameters
 
OK to unregister? (y/n)

 
If you choose Y, the plug-in’s registry entry is removed. The following message is displayed:
EAI Run-Time Plug-In Registration successfully removed
Example
To unregister the eaidb plug-in from the server called hercules (the computer on which you are running this command), enter the following:
sweaireg UNREG eaidb
When prompted, enter Y to proceed with un-registering the server plug-in.

Copyright © Cloud Software Group, Inc. All rights reserved.
Copyright © Cloud Software Group, Inc. All rights reserved.