Copyright © Cloud Software Group, Inc. All Rights Reserved

Overview

All of the Action Processor configuration settings are specified in the Action Processor’s configuration file, which is located as follows:

APDir\apConfig.xml

where APDir is the directory in which the Action Processor is installed (which defaults to “TIBCOActProc”). The location of this directory on your system will depend on which Web Application Server is hosting your Action Processor.

If changes are made to any of the Action Processor configuration settings, you must restart the Action Processor so it picks up the changes to apConfig.xml. To restart the Action Processor, stop and restart the Web Application Server.

The Action Processor configuration settings are described in the following subsections.

Note that Secure Sockets Layer (SSL) can be used to secure communications between the Action Processor and the client. However, the way in which it is implemented is specific to the Web Application Server (WAS) you are using. See the documentation for your WAS. Also note that if you access the TIBCO iProcess Workspace (Browser) through HTTPS, you must also access the Action Processor through HTTPS, and vice versa. In other words, you cannot access one through HTTP and the other one through HTTPS.

Copyright © Cloud Software Group, Inc. All Rights Reserved