Viewing Compliance Suite Reports and Output Data

Using TIBCO LogLogic LX or MX or ST Appliance, you can view all the Compliance Suite reports for the device and run them as well as view the output data.

1. Log in to the TIBCO LogLogic LX or MX or ST Appliance as an admin.
2. From the navigation menu, select Reports > NERC.
   Note: You can also access all of your custom reports on the Appliance, including the Compliance Suite reports you installed, by selecting Reports > All Saved Reports.
3. On the Reports page, you can see all of the custom reports you loaded during the installation process.

   The following figure shows a cropped list of the Compliance Suite reports loaded from the NERC XML file.

   Compliance Suite Reports

   
4. Click the Edit button to see the details. Incorporate all the information in the following substeps:
   1. To view the filter parameters, click Columns and Filters.
   2. To view details about a report such as the report name and description, click Properties.

      The following figure shows the details of the NERC: Failed Logins report.

      Failed Logins Report Details

      
5. Run the report to view the report output data by completing the following steps:
   1. Click Run.

      The report runs and returns data based on the set parameters.

   2. To view detailed drill-down information, click the Count link.
      Note: You can use the Back to summarized results button to return to the main data output view.

      The following figure shows sample results from the NERC: Failed Logins report.

      Failed Logins Report Results

      

      Note: If you want to modify the main data output view, you can modify the report parameters and then run the report again.