Upgrade Considerations

Read these considerations before you start the upgrade process. These considerations are applicable to both High Availability (HA) and standalone setups.

  • After upgrading to version 6.3.0, if you try to access the appliance using Mozilla Firefox, the Secure Connection Failed error message might be displayed. See the Mozilla Firefox support site for tips on troubleshooting security error codes.
  • Advanced Features and Monitoring Console settings before and after upgrade:
    Before upgrading After upgrading to LogLogic LMI 6.3.0
    Advanced Aggregation Monitoring Console
    Advanced Features: On Enabled and available Remains disabled
    Advanced Features: Off Remains disabled Remains disabled
  • In case of Management Station cluster or a High Availability cluster, ensure that all nodes have the same LogLogic LMI and LogLogic LSP versions (the hot fix versions need not match). For more information about HA upgrade, see the TIBCO LogLogic® Log Management Intelligence Administration Guide.
  • If the LogLogic LMI appliance uses LogLogic TCP as the message routing protocol, it is recommended that the source and destination appliances have the same LogLogic LMI version, for best compatibility.
  • To properly forward Check Point data, you must update both your sender and receiver LogLogic LMI appliances to the same LogLogic LMI release.
  • Even if you disable the SSH Daemon at Startup option before upgrading to version 6.3.0, the SSH daemon runs at startup after the upgrade is completed, although the option is displayed as disabled on the Administration > System Settings > General tab. You must disable the option again after the upgrade.
Next topic: Preparing to Upgrade the Appliance