Restoring in an HA pair

To restore a backup to both appliances in a high availability (HA) pair, you must use a different restore procedure

Procedure

From the CLI, use the set failover disable command on the standby appliance in the HA pair to remove it from the pair.
Using HA pair’s virtual IP, restore from the backup as described in Restoring an Appliance.
After clicking Restore, wait for a few minutes if the following message is displayed:
```
This site can't be reached
```
Use the set failover configure command on standby appliance to configure the standby appliance to rejoin the HA pair.
When prompted This appliance shall be the destination of the initial data migration, enter Y.

After the failover is configured and the migration completes, the HA pair is available with the restored data on both appliances.