Editing an Aggregation Rule

When the existing aggregation rule is updated in the system, the aggregated data is reset and computation starts again from the updated time, and the corresponding filter Blok is also updated automatically.

Procedure

  1. Navigate to Administration > Advanced Features > Rule Management and click the Aggregation tab.
  2. On the Aggregation page, click the rule name that you want to update.
    The Details panel opens on the right side of the page.
  3. Click Edit and make the necessary updates.
    For more information about fields, see Adding an Aggregation Rule.
  4. Click Save to save the updated information.
    The updated rule is displayed on the Aggregation page.

Result

If you change any of the fields, the aggregation start time is updated on the Aggregation page.

If you change the description or re-enable a disabled rule, the pre-calculated aggregation data before the updated rule start time is not purged from the system until the retention time elapses. Updating any other field results in purging of the data that was stored before the updated rule start time.