unset Command

The unset command removes certain configurations from the appliance.

Type the following command from your command line: 

unset [ data migration | net ]
unset Syntax Parameters
Parameter Description
data migration Removes the data migration configuration for the appliance.
net Removes a configured network interface from the appliance.

These commands have no arguments or keywords.

Note: Network configuration changes can conflict with cluster configurations, so a cluster must be disabled before you can change network configurations using the unset net command.

Example

On an appliance configured with two NICs (eth0 and eth1), to remove eth1 and leave eth0 as the only configured NIC: 

> unset net
Please select the network interface to unconfigure.
0. 10.1.35.5 eth0
1. 10.1.35.6 eth1
2. Do not unconfigure a network interface. Exit now.
> 1
Network interface eth1 has been designated for unconfiguration.
You must save the change for it to take effect.
> save