Re-imaging the Appliance with an SD Card

You can install LogLogic LMI by using an internal SD card.

Warning: All data will be deleted.

Procedure

  1. Reboot or power cycle the LogLogic LMI appliance.
  2. Press F11 to enter BIOS Boot Manager.
  3. Select One-Shot BIOS Boot Menu.
  4. Select [Hard drive] Internal SD: IDSDM.
  5. Observe the progress via a terminal and enter y when the following prompt is shown: 
    "This process will destroy all data and configuration on the internal hard drives. Do you wish to proceed (y/n)?"
  6. Enter to reboot when following message is shown. 
    "Installation completed successfully. Enjoy!"

What to do next

After the installation is complete, make sure that the boot order is correct.
Next topic: Setting the Boot Order
Previous topic: Installing New SSD Drives