Appliance Software Configuration

After you install the new TIBCO LogLogic® appliance in its rack and power it up, set up the appliance by using the GUI via a web browser, or by using the CLI via a console connection.

Once the appliance is running, you want to configure it for your specific needs. For more information, see the TIBCO LogLogic® Log Management Intelligence User Guide or TIBCO LogLogic® Log Management Intelligence Administration Guide.

To upgrade an existing appliance, see Appliance Software Upgrade.

LogLogic LMI H4, H4R1, H4R2, and H5 appliances come with an embedded SD card that contains an image of the appliance software. This new feature facilitates re-imaging the appliance in case of critical hardware or software failure. For instructions on how to use the backup image for recovery, please contact TIBCO support through the online support portal at: https://support.tibco.com or through email: support@tibco.com.

Note: By default on H4, H4R1, H4R2, and H5 appliances, the labeled iDRAC network interface has an assigned static address, for example https://<IPv4address> or https://[<IPv6Address>]. By connecting the iDRAC network interface to a network infrastructure, the iDRAC web interface becomes available via HTTPS, at https://192.168.0.120, as well as telnet and SSH to the same default IP.