Restoring in an HA pair
To restore a backup to both appliances in a high availability (HA) pair, you must use a different restore procedure
Procedure
-
From the CLI, use the set failover disable command on the standby appliance in the HA pair to remove it from the pair.
-
Using HA pair’s virtual IP, restore from the backup as described in
Restoring an Appliance.
After clicking
Restore, wait for a few minutes if the following message is displayed:
This site can't be reached
-
Use the set failover configure command on standby appliance to configure the standby appliance to rejoin the HA pair.
-
When prompted
This appliance shall be the destination of the initial data migration, enter
Y.
Result
After the failover is configured and the migration completes, the HA pair is available with the restored data on both appliances.
Copyright © Cloud Software Group, Inc. All rights reserved.