Enabling a Node ID in the Archive Path

Warning: This setting is not persisted on upgrades if enabled through LogLogic LMI 5.6.2HF3 or later, or 5.7.0.

Starting LogLogic LMI 6.1.0, archiving with and without the node ID is supported. However, the setting is disabled for new installations and after an upgrade. Hence, if you have been using this feature in prior versions, you must create the archive_config file before upgrading to LogLogic LMI 6.1.0 or later.

If you were not using this feature in prior versions and want to use it after the upgrade, you must re-enable the setting after the upgrade is complete.

For more information and instructions on configuring external storage for an LogLogic ST Appliance or LogLogic EVA in an HA pair, see Failover and External Storage.

Procedure

  1. Create the archive configuration file archive_config under the /loglogic/conf directory.
  2. Add the following line to the file:
    archivedPathWithId=1
  3. Restart the engine_archive.