Appliance Software Configuration

This section applies only to TIBCO LogLogic® Log Management Intelligence appliance.

For instructions to set up TIBCO LogLogic® Enterprise Virtual Appliance, see TIBCO LogLogic® Enterprise Virtual Appliance Quick Start.

Setting up a new appliance
After you install the new TIBCO LogLogic® appliance in its rack and power it up, set up the appliance by using the GUI via a web browser, or by using the CLI via a console connection. For more information, see:
Upgrading an existing appliance
To upgrade an existing appliance, see Appliance Software Upgrade.
Specific configuration
After the appliance is running, you configure it for your specific needs. For more information, see:
Reimaging an appliance
LogLogic LMI H4R1, H4R2, and H5 appliances come with an embedded SD card that contains an image of the appliance software. This feature facilitates reimaging the appliance in case of critical hardware or software failure. For instructions on how to use the backup image for recovery, contact TIBCO support through the online support portal at: TIBCO Support website or through email: support@tibco.com.
Note: By default on H4R1, H4R2, and H5 appliances, the labeled iDRAC network interface has an assigned default static address of 192.168.0.120. By connecting the iDRAC network interface to a network infrastructure, the iDRAC web interface becomes available via HTTPS (https://[<IPv6Address>]) as well as via telnet and SSH to the same default IP.