LogLogic LMI Ports

This section contains all ports that are open on a LogLogic LMI host, including TIBCO LogLogic® Management Center Agent and LogLogic LSP ports.

LogLogic® Universal Collector ports are not documented in this table.

A port serves as a destination on either the appliance or a foreign host depending on direction. In the following tables, inbound direction refers to the port number on the local appliance and outbound direction indicates the port number on the remote host.

Socket interface: The LogLogic LMI appliances use a dual stack IPv4/v6 configuration by mapping the IPv4 addresses of the appliance into the IPv6 address space.

Note: Some ports might not be used at all times such as when HA mode is enabled.

References to IPv6 in the following table do not indicate being able to collect data using IPv6, and hence, the reason the appliance has a dual stack configuration. All external communication must still occur over IPv4.