Configuration of LogLogic iDRAC
You must configure the iDRAC network connectivity.
Beginning with H4 appliances, TIBCO LogLogic®Appliances include the Dell iDRAC utility for a more convenient low-level TIBCO LogLogic® Appliance administration.
The iDRAC interface is available as a local console and a web interface. The web interface is enabled by default on all TIBCO LogLogic® appliances, and relies on the iDRAC-designated interface being connected to the network infrastructure. If this interface is left disconnected, the iDRAC interface is not accessible remotely, but is still accessible in the local console.
By default on TIBCO LogLogic® appliances, the labeled iDRAC network interface has an assigned static IPv4 address of 192.168.0.120/24. By connecting the iDRAC network interface to a network infrastructure, the iDRAC web interface becomes available through HTTPS, at https://192.168.0.120 as well as telnet and SSH to the same default IP.
For instructions to change the network connectivity from the local console, see the TIBCO LogLogic® Log Management Intelligence Hardware Installation Guide.