Import or Export Entities Between Appliances
To share certain configured information from one appliance to another, you can import or export the information as entities.
To repeat configuring the same entities on multiple appliances, you can configure them on one appliance, export them, and then import to other appliances.
List of Entities That Are Imported or Exported from the GUI
You can import and export the following entities from the GUI:
- Alert Templates
- Alerts
- Custom Reports
- Devices and Device Groups
- Search Filters
- Suites
- Users
List of Entities That Are Imported or Exported from the CLI
You can import or export the following entities only from the CLI:
- Advanced Dashboard
- Aggregation Rules
- Bloks
- Data Models
- Enrichment lists
- Groups and nested groups
- Triggers
To export these entities, the Advanced Features must enabled on the Administration > System Settings > General tab > Advanced Features Settings section. See Advanced Features. You can import entities when Advanced Features is disabled; however, you cannot view them until you enable Advanced Features.
Important Considerations
By default, imported triggers and aggregation rules are disabled. After importing, perform the following actions as applicable:
| Item | State after importing | Required action item |
|---|---|---|
| Triggers | Disabled and not synchronized | Enable and synchronize the required triggers from the GUI. See Managing Triggers in TIBCO LogLogic® Log Management Intelligence User Guide. |
| Aggregation rules | Disabled | Enable the required aggregation rules from the GUI. See Managing Aggregation Rules in TIBCO LogLogic® Log Management Intelligence User Guide. |