uc_reload Reload Configuration

Note: LogLogic^® Universal Collector must be started.

This command is used to update the active configuration without stopping the whole process.

To update the current configuration, the command is:

For Windows: uc_reload.bat

For RHEL, SUSE: uc_reload

Example 1: You want to update the active configuration ‘conf1’.

Enter the command to apply a new configuration to the LogLogic^® Universal Collector by using the CLI located in <INSTALL_DIR>/tools.

uc_reload.bat

The active configuration is updated.

Example 2: You want to check the impacted process during an update of the configuration.

Enter the following command:

uc_reload.bat -dryrun -vb

Goal	Syntax	Options
Reload the current configuration to apply changes	`uc_reload`

Note: There is no need to enter the name of the configuration because it is the current configuration, which is automatically updated.