Configuring the Forwarding Process

Procedure

  1. In the Forwarding section, modify the following values:
    Forwarding
    Address Enter the IPv4 / IPv6 address or host name of LogLogic LMI.
    Port

    Select the LogLogic LMI port or enter a port.

    - 5515 for secured connection (configurable in LogLogic LMI)

    Test connection Test the connection between LogLogic® Universal Collector and LogLogic LMI.
    Forward UC Internal Logs Define whether the LogLogic® Universal Collector internal logs are sent to the remote LogLogic LMI by selecting ON.
    Compress Messages If the connection is slow, you can configure the logs to be compressed for a more rapid flow of data. Define whether the logs are compressed by selecting ON.
    Advanced
    Reconnection Enter the reconnection frequency to LogLogic LMI (in seconds)
    Session timeout Enter the session timeout to LogLogic LMI (in seconds)
    UC Binding interface

    If there are multiple network interfaces, enter the IP address that the LogLogic® Universal Collector uses when establishing the connection to LogLogic LMI.

    Default: 0.0.0.0

  2. In the Message Buffering section, modify the following values:
    Message Buffering
    Buffer size (MB)

    Enter the buffer size in megabytes. (Default: 100 MB)

    Scheduled Forwarding

    Define the period of time during which the logs are sent to the LogLogic LMI (time window) by selecting ON.

    Daily Start Define the beginning of the time window. If sendingWindow = true in the above parameter, define the time (hour and minute) when the event starts to be sent (Default: 23:00)
    Daily Stop Define the end of the time window. If you set sendingWindow = true in the above parameter, define the time (hour and minute) when the event stops to be sent (Default: 05:00).
  3. Click OK.
    The list of LogLogic LMI connections is updated.
    Note: The configuration of LogLogic® Universal Collector has finished. When the certificate has expired, you must follow the procedure from the beginning. You can use the same CSR you used if you have stored it earlier.