Configuring LogLogic® Universal Collector Default Parameters

During installation, if the parameters are set with the default values, you can change the configuration values later.

Procedure

  1. Stop the LogLogic® Universal Collector service. For details, see Starting and Stopping LogLogic® Universal Collector Service.
  2. Open <UC_HOME>\conf\uc.properties file by using a text editor.
  3. Update the configuration parameter values and save the file.
    The following properties can be updated after installation.
    Parameters Description
    USER_INPUT_INSTALL_DATA_DIR The location of the data storage directory. The default location is <UC_HOME>/.
    Note: Use the forward slash (/), and not the backward slash (\) as the directory path separator.
  4. Run the following command to reflect the changes:
    Windows: <UC_HOME>\bin\setup.bat

    Linux: <UC_HOME>/bin/setup

  5. Start the LogLogic® Universal Collector Service. For details, see Starting and Stopping LogLogic® Universal Collector Service.