| Endpoint Name
|
Type an endpoint name for an EMS connection, or click
 to select one.
Note: This field can be changed to
Customized User Selection filed, if you change the parameters in the other fields.
|
| Host (URL)
|
The syntax is
host: port, where:
host is the URL or IP address of the machine on which the EMS server runs.
port is the TCP port number.
These values match the ones to which the Substation ES Administration interface is connected.
Default:
TIBCO.EMS.Server:7222
|
| CHECK
|
Click this button to check whether the host URL you have provided is correct. If the host URL is correct,
Checked successfully is displayed. Otherwise an error message is displayed.
|
| User Name
|
The user identifier if a special identification applies to the connection.
Default:
admin
|
| Password
|
The password associated with the username if a special identification applies to the connection.
|
| Destination Type
|
The type of the destination to which the Substation ES Administration Interface listens. The options are
Queue (default) or
Topic.
|
| Queue or Topic Name
|
The name of a queue or a topic to which Mainframe WebUI sends the command request. This name is the same as the one used by the Substation ES Administration interface.
Default:
tibss.admin.sxs.request
|
| Connect
|
Click this button to verify whether the EMS server connection setup is correct.
If the connection is successful,
Connected successfully is displayed, and the connection is applied.
If an error occurs,
Failed to connect to the server at
host is displayed.
The field where the error occurs will be highlighted, and the instruction message will be displayed below the field.
|
| Reset
|
Click this button to reset the changes and return to the previous page.
|
