Installing the GDSN Component

As per your requirement, you can install the GDSN plugin over the main MDM version of TIBCO MDM.

Procedure

Extract the archive the product was delivered in.
Run the TIBCO UniversalInstaller application. This starts up the Universal Installer through which you can install TIBCO MDM GDSN Plugin.
After a short delay while the installer initializes, the Welcome dialog is displayed. Review the information in the Welcome dialog and click Next.
The License Agreement dialog is displayed. Review the terms of the license agreement and, if you agree to them, click I accept the terms of the license agreement. Then click Next to continue with the installation.
The Installation Type dialog is displayed. By default, Typical will be installed.
Click Next. The Environment Type dialog is displayed.
A TIBCO installation environment is used for software installations and consists of a Name and Directory. Products installed into different installation environments do not share components; therefore you can keep product installations completely isolated from each other.

Note: Since the GDSN component is an add-on component to MDM, ensure that you provide the MDM environment here. If you provide a different path, an error is displayed.
Click Next. A list of the components that will be installed, the location where they will be installed, and the total size is displayed.
Click Install for installation to proceed. The progress and the final results are displayed.
Click Finish to exit the wizard.