Starting pDNI Template

After saving the new template, a list of templates is displayed and you see the new template.

To start a pDNI template, complete the following steps.

    Procedure

  1. On the right side of the line for that template, the action should specify as Start.

  2. Click Start to start the template.
ResultInternet Server communicates with DNIDaemon to start the template. A message displays whether the file has been started successfully.

A start request can fail for a variety of reasons. The most common reasons are:

  • An invalid parameter or invalid parameter value was defined.

  • The LocalDirectory for a DNI Send was not found.

  • Post Action SuccessFile, FailureFile, and NetworkErrorFile point to a directory that does not exist (when the Post Action is Move)

If the template does not start successfully, you can follow the procedure "Verify that the pDNI template is transferring files" to determine the cause of the failure.