Create Transfer Definition for Defined User and Server Definitions

To create a transfer definition for the defined user and server definitions, perform the following steps:

Procedure
1. Go to Transfers > Internet Server Transfers > Add Transfer.
2. Enter the required information listed in the table below.

   Parameter	Instruction
   Client File Name	Enter any value; this field is ignored.
   Server File Name	Enter the target directory where the file is written.
   Directory Transfer	Set to Yes.
   Description	Set to a descriptive text value.
   Authorized UserId	Select the user ID created in the prior step.
   Server Name	Select the server created in a prior step.
   Transfer Direction	Set to Upload.
   Client Protocols Allowed	To accept all incoming protocols, set to All. To accept Platform Server requests, set to Platform Server. To accept Platform Server SSL/TLS requests, set to Platform Server SSL/TLS.
   Virtual Alias	This value defines the directory that the user sees when logging into Internet Server. We suggest not entering any spaces and leave out slashes and backslashes. The Virtual Alias is used in the DNI Template > DNI Command parameter.

3. Enter the required information in the Additional Transfer Information.
4. To create files and return error if the file exists, set the write mode to Create.
5. To create or replace existing files, set the write mode to Create-Replace.
6. To create or replace existing files and to create directories as needed, set the write mode to Create-Replace-New.
7. Click Add to add the transfer definition.