Starting OFTP2 Service

To start the OFTP2 service, complete the following steps.

    Procedure
  1. Go to Administration > Transfer Servers > OFTP2 Server > OFTP2 Server Status.

  2. Select the OFTP2 server host.

  3. Click Server Status to get the current status of the OFTP2 service on this host.

  4. Click Start Server to start the OFTP2 service on this host.

  5. Click Stop Server to stop the OFTP2 service on this host.

ResultOnce the OFTP2 service is started, FT accepts incoming OFTP2 transfers.