Client Sends PGP-Encrypted Data to MFT Internet Server

Make sure that a public key is associated with the client user. See Client Sends or Receives PGP encrypted data for more detail.

Configure the transfer definition to decrypt and optionally, verify the PGP signature. The transfer definition contains the PGP configuration information.

To send the PGP-encrypted data to the MFT Internet Server, complete the following steps.

    Procedure

  1. Go to Transfers > Internet Transfers > Manage Transfers.

  2. On the Manage Transfers page, click Transfer Id.

  3. Go to the PGP Information tab.

  4. Configure the following fields described in the table below:

    Field Instruction
    Decrypt Select this checkbox to decrypt the data.
    Verify Signature Select this checkbox to verify whether the signature is valid for any user.
    Verify User Signature When checked, verifies if the signature is valid for the transfer user.

  5. Click Update to update the transfer definition.

    Note: When you perform the upload for this transfer definition, the data is decrypted using the MFT PGP private key. The signature is validated using the PGP public key of any user defined to MFT, or to the user that performed the file upload.