Directory Transfer Parameters
The following table shows parameters you can use to perform directory transfers:
| Parameter (Alternate Specification) | Description |
|---|---|
| ScanSubDir (ssd) | Defines whether all subdirectories from the file path are scanned.
Note: This parameter only applies to directory transfers.
The valid values are Y or N. |
| StopOnFailure (sonf) | Defines whether to stop transferring the rest of files in the directory when the current file transfer fails.
Note: This parameter applies to directory transfers and distribution list transfers.
The valid values are
Y or
N.
|
| Test | Defines whether to display the local and remote file names that are transferred without doing the actual transfers, so that you can verify whether the file names are correct before the actual transfers.
Note: This parameter applies to directory transfers and distribution list transfers.
The valid values are
Y or
N.
|
| ExecPostProc | Defines whether to have the postprocessing action execute after each file in a directory or after the last file in the directory or distribution list is transferred. The valid values are |
| ExecPreProc | Defines whether to have the preprocessing action execute before each file in a directory or before the entire directory or distribution list is transferred. The valid values are |