Modify a flow line link

You can add a new link or change an existing link.

1.	Right-click the flow-line link and choose Access/Modify.

2.	Click the flow-line link that you want to modify and click Modify.

3.	If in single selection mode, select a different link to connect to and click OK, otherwise follow the steps in the wizard.

This toggles between the wizard mode and single selection mode.

Note: Choose to link to a master or draft diagram by choosing the relevant option from the Diagrams drop-down list.

Note: You can navigate to a specific level in the diagram list by entering the number in the Level Select box and clicking Go.