Run isetup to Add an Additional Configuration Instance

Follow the steps mentioned below to run isetup to add an Additional Configuration Instance.

  1. Log in to USS by using the iadmin user ID.

  2. Change to the temp directory created when you processed the run file.

  3. Run the isetup program. Select option 2 on the initial screen:

  4. Enter z/OS Userid for Server administration, PTH Administrator ID, and password. Press Enter to accept the defaults. For more information, see OPSYS Server Administrator ID (iadmin).

  5. Enter, or accept the default value for the z/OS Server System Support ID. For more information, see ibi WebFOCUS Reporting Server System ID (iserver).

  6. You are presented with the default settings and asked whether to proceed. Type N. Specify values for EDACONF, EDACONFLIB and HTTP_BASE_PORT that do not conflict with your existing configuration.

  7. Accept the EDAHOME location.

  8. Provide a new EDACONF location. Typically this location simply adds a suffix to the existing EDACONF, such as ../wfs_test.

  9. In the next prompts for EDACONFLIB and EDAPFRU, the proposed value uses the same suffix. Accept it or edit as appropriate.

  10. Continue through the remaining prompts for APPROOT, HOMEAPPS, and JDK_HOME.

  11. Enter the Customer ID. It is provided with your WebFOCUS software.

  12. At the HTTP Listener Port prompt, enter a new value. If you accept the default value, you cannot run your old and new configurations at the same time. Also enter the SMTP Mail Server if required.

  13. Review the configuration options and enter Y to Accept and Proceed.

  14. You are prompted to review the selections and accept and proceed, start over, or quit. Type Y to accept and proceed.

  15. After a successful creation of a new configuration, you receive this last prompt:

For initial testing purpose, you can start the Server by entering Y. However, for production Servers, it is recommended that you start by submitting istart from your new EDACONF PDS.