Updating TIBCO Flogo Capability Configuration

To update the fluentbit sidecar deployment preference for Flogo applications after the capability has been provisioned, use the Update Configuration option.

Procedure

1. In TIBCO Control Plane, click Data Planes from the left navigation.

2. On the Data Plane card of your choice, click Go to Data Plane.

3. In the Capabilities section, click FLOGO capability.

4. On the TIBCO Flogo® capability page, click the Update Configuration link at the upper-right corner.

5. On the Provisioning TIBCO Flogo® Capability page:

   • Storage Class section: Review the configured Storage Class information. This section is read-only and cannot be modified using the Update Configuration option.

   • Ingress Controller section:

     • Review the list of available ingress controllers.

     • You can either:

       1. Select an existing ingress controller from the list, or

       2. Click Add Ingress Controller, configure the required fields, and click Add to create and add a new ingress controller to the selection list.

6. Click Next.

7. Review and, if necessary, edit the Path Prefix in the text box for the ingress resource used to provision public APIs.

8. Review the Deployment of fluentbit sidecar for Application logs toggle settings for TIBCO Flogo applications.

   • The toggle reflects the deployment preference set during the initial provisioning or the last upgrade. You can update the toggle settings at this step.

9. Select the I have read and accepted the TIBCO End User Agreement (EUA) checkbox to accept the End-User Agreement.

10. Click Update Configuration.