Interactive Configuration Options

The Team Studio installer command is TIB_sfire-dsc-6.6.0_linux_x86_64.sh. By appending the following options to this command, you can customize the configuration as described.

Installer options.
Example
TIB_sfire-dsc-6.6.0_linux_x86_64.sh --silent --chorus_user=JDoe
Option Description
--disable_spec
Skip the system requirement checks. If you do not have a supported system, you can still attempt to run the installer using this option, but it is not recommended.
--chorus_user=CHORUS_USER
Specify the Team Studio user. (The default is chorus)
--chorus_path=CHORUS_PATH
Specify the Team Studio installation path. (The default is /usr/local/chorus.)
--data_path=DATA_PATH
Specify the Team Studio data directory (The default is /data/chorus.)
--passphrase=PASSPHRASE
Specify the passphrase for encrypting and recovering passwords (the default is ' '.)
--chorus_only
Set up only the Team Studio collaboration framework; do not install the Team Studio workflow editor.
-s, --silent 
Run script silently. If you choose this option, you must specify the necessary parameters listed above.
Note: Using these advanced options is not recommended, except in a debug or recovery procedure. In the following example, a user needs to recover a file from the installer package, the user can extract the contents without running the install script to a specified directory.
Example

./TIB_sfire-dsc-6.6.0_linux_x86_64.sh --noexec --keep --target /tmp/
Advanced installer configuration options
Option Description
--confirm
Ask before running embedded script. This refers to the script that configures and installs Team Studio after the files are extracted.
--noexec
Do not run the embedded script.
--keep
Do not erase the target directory after running the embedded script.
--nox11
Do not spawn an xterm instance. Use this option if you are installing Team Studio on a headless server.
--nochown
Do not change the owner of the extracted files.
--target NewDirectory
Extract the installer files in the specified new directory.
--tar arg1 [arg2 ...]
Access the contents of the archive through the tar command.
Related reference