Spotfire Server 11.2
This page lists system requirements for TIBCO Spotfire® Server version 11.2.
System requirements for Spotfire Server version 11.2
Hardware | |
---|---|
Processor |
Note: x86
processors are not supported.
|
RAM |
|
Hard disk space |
|
Software | |
---|---|
Operating system | The following operating systems are
supported:
Note: Only 64-bit versions of the operating systems are supported.
|
Spotfire Server database | Oracle *:
Microsoft SQL Server ***:
PostgreSQL:
Note: The
Spotfire Server database uses third-party software that must be installed prior
to the TIBCO Spotfire® software installation. It is possible, but not
supported, to run the database and Spotfire Server on the same computer. If you
do so, refer to the database vendor for database system requirements.
Note: The size
of the Spotfire Server database schema(s) is approximately 500 MB at the time
of creation; there is no upper limit for the size, unless restricted by
database limitations.
|
Spotfire software | Spotfire Server 11.2.x, with a Spotfire
11.2.x deployment, supports connections from Spotfire Analyst and web client
11.2.x.
Upgrades:
For more information about Spotfire versioning and upgrades, see https://docs.tibco.com/pub/spotfire/general/LTS/spotfire_LTS_releases.htm. |
Authentication method |
|
Installation privileges on Windows | Spotfire Server 11.2.x must be installed under a Windows user account with full administrative privileges. |
Locale | The server should run in an English (United States) language setting. |
Web browser (for server administration/configuration pages) | The following web browsers are supported:
|
Network | IPv4 or IPv6 |
Node manager (optional) | To run any Spotfire services (see below) on a computer, the computer must first have a node manager installed. There is no separate system requirement for the node manager; this is covered by the requirements for the service. |
Spotfire services (optional) | The following are the supported services
that can be provided through Spotfire Server:
Note: To run
Spotfire services on a computer, the computer must first have a node manager
installed. There are no separate system requirements for the node manager; this
is covered by the requirements for the service.
Important: Do not install the
TERR service
on a node that contains other services. Doing so can cause the services to
become unresponsive.
|
Information Services Data Sources (optional) | To use Information Services for server-side
access to JDBC data sources, a driver for the corresponding data source must be
installed on the server.
Some data source drivers are included out of the box with Spotfire Server. See the Spotfire Server and Environment Installation and Administration manual for more information. |
Load balancer (optional) | Load balancing Spotfire Servers can be
achieved using Apache httpd with the mod_jk module enabled. This solution is
tested and recommended.
It is also possible to use a different load balancing solution, as long as it supports session affinity, which ensures that a client communicates with the same server for the duration of the session. |
Clustering (optional) | Multiple Spotfire Servers can be clustered for failover and improved scalability using Apache Ignite, which is included out of the box. |