Starting or stopping Spotfire Server (Windows, no service)

If you did not install a Windows service you must start Spotfire Server manually.

Prerequisites

You have successfully completed the initial configuration steps so that the System Status page of the configuration tool contains four green check marks.
System Status page of Spotfire Server configuration tool with 4 green check marks

Procedure

  1. Log in to the Spotfire Server computer as an administrator.
  2. Open a command prompt and go to the following folder: <installation dir>/tomcat/bin.
  3. Run the startup.bat file.

Result

Spotfire Server starts.
Note: The server will stop running if you close the command prompt or log off from the computer.