Installation of Spotfire Server during upgrade
When you install Spotfire Server, the upgrade tool is installed as well.
Before installing the new version of
Spotfire Server,
note the following:
- Configure the new server to use the same ports as the previous installation. This will not cause a port conflict if you have followed steps 1 and 2 in Upgrading Spotfire.
- Do not start or configure the newly installed server before running the upgrade tool.
- If you intend to copy information from the old version, do not uninstall it until the new version of Spotfire Server is in place.
- Some Spotfire releases are designated long-term support (LTS) versions; for information about how LTS versions differ from Innovation (non-LTS) versions, see https://spotfi.re/lts.
For general instructions on how to install Spotfire Server, see Installation.