Analysis Configuration: Output Options

Expand the Analysis Configuration node in the tree view, and then expand the SPC Characteristics node, the Calculated Variables node, and the desired variable node, then select the Output node to display the Output options in the properties page. These options provide controls for the inclusion of additional charts to be output for the selected Characteristic or IQC variable. Note that it is possible to exclude the default chart type using these controls as well; see X-Bar & R below. Select any number of optional output controls to include them as output, additional to the default chart for the Characteristic or IQC variable. 

 Normal Output. Select any combination of these check boxes to include the respective charts in the output.

X-Bar & R. Represents the default chart type if the option was not changed in the Variable options view. If this check box is cleared and one or more of the subsequent charts are selected, it will be excluded from output.  

X-Bar Only

Select to output an individual X-Bar chart not having the complementary R chart on the same graph.

R Only

Select to output an individual R chart separate from its matching X-Bar chart.

SixGraph

Select to include. Click the Options button to display the Select the contents and layout for the six graph summary dialog.

Capability Histogram

Select to include.

Capability Summary Tables

Select to include.

Runs Tests Summary Table

Select to include.

Descriptives

Select to include. 

 Outliers Summary. Select to include.

Non-Normal Output.

X Non-Normal

Select to include.

Descriptives

Select to include.

Outliers Summary

Select to include.

Capability Histogram

Select to include.

Capability Summary

Select to include.

Reset to default

Click this button to reset all options in the Output properties page to the default settings.