Constrained Surface Design Results - Review Constraints Tab

Select the Review constraints tab of the Constrained Surface Design Results dialog to access options to review and modify the design constraints.

Review constraints

Click the Review constraints button to display a spreadsheet containing (1) the initial factor constraints, (2) the additional user-defined constraints, and (3) the final set of constraints (after discarding redundant constraints) for the experimental region. Note that in this spreadsheet the initial factor minima and maxima are expressed as general linear constraints (refer to the Introductory Overview for a discussion of linear constraints in this form).

Factor min/max values

Click the Factor min/max values button to display a spreadsheet containing the factor minima and maxima (i.e., the initial factor constraints).

2D Scatterplot of points

Click the 2D Scatterplot of points button to display the Select factors for 2D scatterplot dialog, in which you select two factors for the scatterplot of vertex and centroid point values.

3D Scatterplot of points

Click the 3D Scatterplot of points button to display the 3D scatterplot of the constrained experimental region. If there are more than three factors in the current design, then, after clicking the 3D Scatterplot of points button the Select factors for 3D Scatterplot dialog will be displayed, in which you select the three factors for the 3D scatterplot.

Plot vertex points only

By default, only the vertex points are plotted in the 3D scatterplot. If you clear the Plot vertex points only check box, then vertex points and centroid points will be plotted.