When you use the FastPath process with a trigger service, consider the following requirements if the endpoint is EMS ESB.
Modify
Output Dest Type as needed.
Modify the
Output Message properties as needed:
Modify Priority as needed.
Modify Expiration as needed.
Modify Message Type as needed.
B(ytes): send as a bytes message with user data from BES buffer. The size is determined by the User Data Length.
T(ext): sends a text message with the buffer data. The TEXT message ends with a null-terminator.
S(tream): sends a stream message with user data from BES buffer. The size is determined by the User Data Length.
M(ap): sends a MAP message using data from BES buffer in one field named
DATA. The size is determined by the User Data Length.
Note:
The
PROP field is not supported with FastPath, and should not be used.
The EMS ESB does not support the use of the
Publish To Len (Dyn) field with FastPath.
Definition Rules
When using the FastPath process with a trigger service, consider the following requirements if you are using an EMS ESB.
Note: The CICS Request/Reply (REQR) can deploy a FastPath Trigger for both EMS and Rendezvous ESBs. The REQR process automatically adds a tibss-envelope field to the message when FastPath is configured.
In order to use FastPath to process a trigger that is configured with an EMS endpoint, the ESB and trigger definitions must meet the following requirements:
The ESB SIP member must have
EMS-USE-PROP set to
Y.
The trigger definition must use
Output Method 2 or 3 only.
The trigger definition must not include settings for these fields: