Configuring Sample Applications

This section describes how you can configure an imported sample project before running it. To configure process variables for a process, perform the following steps:

Procedure

  1. In the project explorer, expand the imported project.
  2. Under the expanded project, expand Processes.
  3. Under Processes, expand substationrecipeservices or substationtriggerservices.
    A list of process/es is displayed.
  4. Double-click any process from the list to open it.
  5. To edit the process variables for the selected process, click anywhere in the process editor window.
    The properties tab for the process is displayed.
  6. Under properties, click Process Variables.
  7. Click on each variable to set the appropriate value.
  8. Save the project.
  9. On the menu, click Run.
  10. Click Run Configurations.
  11. Expand BusinessWorks Application.
  12. Click BWApplication.
  13. Ensure that SubstationRecipeServices and SubstationTriggerServices applications are checked.
  14. On the menu, click Run.
  15. Click Debug Configurations.
  16. Repeat steps 11 to 13.