Installation and Upgrade Guide > Container Orchestration Using Kubernetes > Pre-Configuration of the Runtime Environment (On-Premises/Private Cloud only): > Installing the TDV HAProxy Service using the Quick Start Script
 
Installing the TDV HAProxy Service using the Quick Start Script
The Quick Start script shipped with the TDV Helm Charts archive can be used for installing a TDV HAProxy service.
Run the script run_tdv_haproxy.sh (which is part of the TIB_tdv_<version>_kubernetes.zip file) on your Kubernetes master node.Refer to the section TIBCO Data Virtualization(R) Container Distribution for a list of files that are pre-packaged with TDV.
Run the following command:
./run_tdv_haproxy.sh [-hv] [--dry-run] [--skip-wait]
[-d] [--del-secret]
[--name <name>] [--set <key1>=<val1>,<key2>=<val2>,...] [-f <yaml file>] [--values <yaml file>]
 
The table below gives a description of the different parameters used with the script.
Parameter
Description
Comments
--dry-run
Show output of execution without actually executing the script.
 
--skip-wait
Skip wait check for TDV pods.
 
-h
Help for using the script.
 
-v
Enable verbose mode output.
 
Deletion Settings
-d
Delete and uninstall TDV HAProxy helmchart if already exists with same --name <name>.
 
--del-secret
Delete gateway secret for TDV HAPRoxy service (default name "tdv-haproxy-gateway-certs-secret")
 
Helm Chart Settings
--name
Set <name> for helmchart (default is "tdv-haproxy").
 
-f <yaml file>
Pass TDV helm chart parameters from a yaml file.
 
--values <yaml file>
Pass TDV helm chart parameters from a yaml file.
 
--set <key1>=<val1>,<key2>=<val2>,...
Pass TDV helm chart parameters to helm chart for runtime configuration.
It is recommended that you run “run_tdv_haproxy.sh -h” for a complete list of the various configuration settings that can be tuned using this option.
Note: You can only run one TDV HAProxy service at a time.