Triggering Reintrospection
You can set up a trigger to reintrospect based on a JMS event, a system event, timer event, or user-defined event. See Triggers for more information about triggers.
To set up a reintrospection trigger
Right-click in the Studio resource tree where you want the trigger to reside.
Type a name for the new trigger and click OK.
|
2.
|
Specify the condition that is to invoke the trigger: JMS Event, System Event, Timer Event, or User Defined Event. |
|
3.
|
For Action Type, select Reintrospect Data Source. |
|
4.
|
Specify the data source in one of these ways: |
|
—
|
Type the resource-tree path and data source name in the Data Source Path field. |
|
—
|
Click Browse and in the Select a datasource dialog box navigate to the data source, highlight it, and click OK. |
|
5.
|
Optionally, specify email information (in the To, Cc, Bcc, Reply-To, Message Subject, and Message Body fields) to send email when the trigger fires. |
|
6.
|
Select one or both of these options: |
|
—
|
Do Not Persist Detected Changes—If you do not want to persist detected changes. |
|
—
|
Do Not Send If No Changes Detected—If you do not want email sent if no changes were detected. |
|
7.
|
Check Enable Trigger near the top of the panel to enable this trigger. |
|
8.
|
Use Studio Manager to track the status and history of when this trigger runs. |