Configuring a RoundRobinWithFailOver Target Operation Group

To configure a target operation group of RoundRobinWithFailover type, select the type of the target operation group as RoundRobinWithFailover. Follow these steps:

Procedure

  1. Click the Target Operation Groups tab.
  2. Enter the value for the following fields:

RoundRobinWithFailOver Target Operation Group Configuration
Parameter Description
Group Name
  • Specifies the name of the target operation group. This can be any name defined by a user.
  • This is a required field.
Description A short user description of the target operation group.
Type Select RoundRobinWithFailover from the drop-down list. See RoundRobinWithFailOver Target Operation Group.
Target Operations Specifies the list of target operations in the group. Add muliple target operations using the Add Target Operation ()icon to a target operations group. The target operations must be configured under the Target Operations group.

  1. Save the changes to the configuration.
  2. Figure RoundRobinWithFailOver Target Operation Group shows the RoundRobinWithFailover Target Operation Group configuration:
    RoundRobinWithFailOver Target Operation Group