Configuring a WeightedRoundRobinWithFailOver Target Operation Group

To configure a target operation group of WeightedRoundRobinWithFailover type, select the type of the target operation group as WeightedRoundRobinWithFailover. Follow these steps:

Procedure

  1. Click the Target Operation Groups tab.
  2. Enter the value for the following fields:

WeightedRoundRobinWithFailOver Target Operation Group Configuration
Parameter Description
Group Name
  • Specifies the name of the target operation group. This can be any name defined by a user.
  • This is a Required field.
Description A short user description of the target operation group.
Type Select WeightedRoundRobinWithFailover from the drop-down list. See WeightedRoundRobinWithFailOver Target Operation Group.
Target Operations Specifies the list of target operations in the group. Add muliple target operations using the Add Target Operation ()icon to a target operations group. The target operations must be configured under the Target Operations group.

  1. Save the changes to the configuration.
  2. Figure WeightedRoundRobinWithFailOver Target Operation Group shows the RoundRobinWithFailover Target Operation Group configuration:
    WeightedRoundRobinWithFailOver Target Operation Group