Installation

When using TIBCO Universal Installer, you can install the plug-in in the GUI, console, or silent mode.

Ensure that you meet all the requirements described in the Installation Requirements section.

Note: The plug-in must be installed into an existing installation environment where ActiveMatrix BusinessWorks or TIBCO Business Studio™ Container Edition is installed. Stop all running processes in the installation environment before the installation.

Before You Begin

Before beginning installation, you must note the directory path for use during installation.

Installing with ActiveMatrix BusinessWorks

To install ActiveMatrix BusinessWorks Plug-in for HL7 with FHIR in an ActiveMatrix BusinessWorks environment, follow the steps found in this document, excluding those found in Adding the Plug-in to TIBCO BusinessWorks Container Edition.

You can install the plug-in by using any one of the following modes:

  1. Installing in GUI mode
  2. Installing in console mode
  3. Installing in silent mode

Installing with TIBCO Business Studio Container Edition

To install ActiveMatrix BusinessWorks Plug-in for HL7 with FHIR in a TIBCO Business Studio Container Edition environment, follow the steps found in this document, including those found in Adding the Plug-in to TIBCO BusinessWorks Container Edition.