Task C: Configure Integration Gateway Properties

After you define the default local integration gateway, specify the integration gateway URL and load the delivered connectors, you must configure the integration gateway properties file. To establish settings for the integration gateway and its delivered connectors, you use the integrationGateway.properties file under

PS_HOME\webserv\peoplesoft\applications\peoplesoft\PSIGW\WEB-INF.

When the gateway server boots, it reads and applies the properties in the integrationGateway.properties configuration file. Changes that you make to the file while the server is running have no immediate effect.

If you want to make changes to the integrationGateway.properties file while the server is running, you can log in to PIA and change the properties online. PeopleSoft Integration Broker reapplies the configuration settings—including the changes—without rebooting.

To Access the Properties File using PIA

    Procedure
  1. Go to PeopleTools > Integration Broker > Configuration > Integration Gateways.

  2. Search the gateway you defined in Task B, Load Gateway Connectors.

  3. Open the gateway and click the Gateways Setup Properties link next to the integration gateway URL field.

  4. In the displayed Gateway Properties Sign-in page, enter User ID and Password.

    Click OK.

  5. In the displayed PeopleSoft Node Configuration page, click the Advanced Properties Page link.

  6. Configure gateway properties in the displayed editor.

  7. Click OK to save the properties.

  8. Click Save to save the integration gateway configuration.

To Configure Integration Gateway Properties

You need to configure the following integration gateway properties:

  • Delivered Connector Configuration

    • ig.isc.serverURL=PeopleSoft_server_name:port ig.isc.userid=username ig.isc.password=password ig.isc.toolsRel=PeopleTools_version

    • Use the supplied Password Encryption Utility to generate an encrypted password for ig.isc.password.