Accessing the Appliance System

Directly connect to the appliance in order to begin the software initialization process.

1. Power on the TIBCO Enterprise Message Service™ Appliance system.
2. Access the appliance as described in Directly Connect to the Appliance for Initial Setup.
   Warning: The appliance runs a health check before starting the software initialization process. If it detects any problems, such as an error in the operating system or hardware, it reports an error. Do not proceed with the software initialization process without first addressing and resolving any errors. Contact TIBCO Support if you require assistance.
3. Log in to the appliance using the tibadm username and default password of test123.
4. When prompted, enter the information specific to your system. The sections below describe the information requested in greater detail.
   Note: Note that all IP addresses must be specified using IPv4 addresses. The appliance does not support IPv6.