Configuring EMS Server Information

Enter primary EMS server network information.

Prompt Description
EMS Server IP/Netmask():

This is the TIBCO Enterprise Message Service server IP address that will be used by client software when connecting to the TIBCO Enterprise Message Service server.

For example: 192.168.3.51/24

EMS Server Gateway IP: (Optional) The EMS Server Gateway provides routed access to the EMS Server IP. Specify this setting if any of your EMS clients need routed access to the server. You do not need to specify the EMS Server Gateway IP if all of your EMS clients are on the same subnet as the EMS server.

If an EMS Server Gateway IP is specified, then once the system is booted and operational all traffic goes through the EMS Server Gateway except SSH logins to the Mgmt IP.

Note: If the EMS Server Gateway IP is specified, then network services such as LDAP, DNS, and KMIP must be reachable by way of this gateway.
Note: The active gateway can be manually changed using the ems-gateway command.

For example: 10.101.1.1/24.

EMS Instance Name (): Enter a name for the TIBCO Enterprise Message Service server instance. For example, inst0. For server naming conventions, see documentation for the server parameter in the TIBCO Enterprise Message Service User’s Guide.
EMS Instance IP Port (): Enter the port number to be used by TIBCO Enterprise Message Service clients connecting to the primary EMS server instance.

This port is used with the TIBCO Enterprise Message Service server IP address to create the server’s listen setting. Appliances in a fault tolerant pair must use different port numbers. For example, if TIBCO Enterprise Message Service instance 0 uses port 7222, TIBCO Enterprise Message Service instance 1 might use port 7223.

NOTE: When setting up a Backup Site appliance for disaster recovery, be aware that the port number entered here will only be used for initial testing. When the Production Site is recovered to the backup site, this information is overwritten and the port numbers will be the same as the original production site port numbers.

Next topic: Configuring Fault Tolerant Behavior
Previous topic: Configuring Host Information