Configuring RStudio Linux Server Edition to Run the Spotfire Enterprise Runtime for R Engine

Configure the Linux server version of the RStudio IDE to work with TERR.

About this task

Perform this task from the Linux server.

Before you begin

You must have installed RStudio version 0.99 or later for the Linux server. (See TERR system requirements for tested versions.)

Procedure

Linux Server administrators should follow the instructions under Specifying R Version in the RStudio Server configuration documentation, found at https://support.posit.co/hc/en-us/articles/200552316.

JavaScript must be enabled in order to use this site.Please enable JavaScript in your browser and refresh the page.

Configuring RStudio Linux Server Edition to Run the Spotfire Enterprise Runtime for R Engine

Configure the Linux server version of the RStudio IDE to work with TERR.

About this task

Perform this task from the Linux server.

Before you begin

You must have installed RStudio version 0.99 or later for the Linux server. (See TERR system requirements for tested versions.)

Procedure

Linux Server administrators should follow the instructions under Specifying R Version in the RStudio Server configuration documentation, found at https://support.posit.co/hc/en-us/articles/200552316.