Securing Persistence Services

To secure a persistence service, complete this task.

Before you beginAll FTL servers must be secure.
    Procedure
  1. Verify that the persistence cluster definition specifies secure transport protocols.
    The client protocol, disaster recovery (DR) protocol, and inter-cluster protocol must be secure. For maximum performance, the cluster set protocol can be a non-secure protocol -- but only if all persistence services of the cluster run within a protected network. Otherwise use a secure protocol for cluster set communications.

    Use only these transport protocols:

    • Secure Dynamic TCP
    • Secure TCP
    • Secure Auto

    For further details, see "Clusters Grid" in TIBCO FTL Administration.