Importing and Exporting JMS Configuration Information from the iProcess Engine Database

You can export and import your JMS provider configuration information from one iProcess Engine database to another using JMS Administration Tool. You may wish to do this:

• If you want to migrate your iProcess Engine environment, for example, from a development environment to a production environment
• As a way of backing up your data, for example when upgrading iProcess Connector for ActiveMatrix BusinessWorks, or if for instance you want to perform some maintenance to your iProcess Engine database that may result in data being overwritten.
Warning:

If you import new JMS provider information to your iProcess Engine database, then you are overwriting the existing JMS provider information that is stored there. If your JMS destination information does not match what is defined in your current iProcess BusinessWorks steps, it will cause those iProcess BusinessWorks steps to fail. You should either:

• Check that the JMS provider information you are importing matches the JMS provider information defined in your iProcess BusinessWorks steps, or
• Re-define your iProcess BusinessWorks steps to use the new JMS provider information you are importing.

The following section describes:

• Exporting JMS Provider Configuration Information
• Importing JMS Provider Configuration Information