Advanced Features

This section describes advanced features in LogLogic LMI.

By default, these features are disabled. A user with administrator privileges can enable the Advanced Features, or set up a High Availability pair for Advanced Features, or both. For more information on enabling the features or setting up High Availability, see the TIBCO LogLogic® Log Management Intelligence Administration Guide.

  • Advanced Search
  • Advanced Dashboards
  • Bloks: Filter, Correlation, and Time Bloks
  • Data Models
  • Enrichment Lists
  • Exporting and Importing Configurations
  • Monitoring Console
  • Monthly index
  • Queries
    • Search queries
    • Scheduled queries
    • Tail queries
    • Distributed Advanced Search queries
  • REST API support for Advanced Search
  • Rule Management:
    • Triggers
    • Aggregation rules
    • Distributed aggregation rules

Important Considerations

  • Advanced Features are not supported on:
    • LogLogic LMI appliances with an IPv6-only configuration.
    • A standby node in a high availability setup.

      However, Advanced Features are accessible using the public IP address or the IP address of the master node. Before configuring HA, you must disable Advanced Features on both master and standby appliances.

  • Use caution when enabling Advanced Features on TIBCO LogLogic® LX1025R1 Appliance, because the memory requirements of these features when in use might cause performance issues. Also, continuous use of Advanced Features on this model can cause the appliance to run out of memory and lead to engine restarts or failure.
  • For information about the behavior of Advanced Aggregation and Monitoring Console features after upgrading to LogLogic LMI 6.3.0, see Upgrade Considerations in the TIBCO LogLogic® Log Management Intelligence Configuration and Upgrade Guide.