TIBCO MDM Installation
You can run the TIBCO installer in different modes, supported on all platforms.
TIBCO MDM may be available on multiple operating systems. However, not all operating system platforms for a specific software version are released at the same time. Refer to the Readme.txt file to locate whether or not TIBCO MDM is available on a particular operating system.
Note: If you select
Simple Installation with PostgreSQL, you can skip the sections from
TIBCO MDM Installation on Application Servers to
Support for Language Pack.
- Simple Installation with PostgreSQL
The simple installation provides minimal prompts and installs standard components in the default locations. You can change the default locations, if required. - Installing TIBCO MDM (Typical Installation)
In the typical installation, the installer presents panels which you can select choices about the product location, and so on. - Installing in Console Mode
Using the Console mode, you can install the software in a non-Windows environment. The installer prompts you for values. - Silent Installation
The TIBCO MDM installer supports silent installation to facilitate automatic installation on to other computers. The silent installation option is based on a silent file which contains all of the information the installer needs to perform the installation. - Configurator
The Configurator is an independently deployable web-based configuration utility that allows you to configure various properties for TIBCO MDM. It can be used for the initial setup of the application as well as for ongoing maintenance of the TIBCO MDM configuration. - Superuser Password
The TIBCO MDM application runs under the context of a UNIX or Windows user. This user account has to be created. - Configuration Requirements
The configuration requirements depend on if this is for a new installation, an upgrade installation, or if any new properties need to be set for a specific release.
Copyright © Cloud Software Group, Inc. All rights reserved.