Sending Files Using the Command Line

Instead of following the Send File command parameter fields display rules, after the first Send File command screen is displayed, you can press F9. And as you press the Page Down key, all the parameter fields in the Send File command are displayed.

1. Enter the command CFSNDF on the command line and press F4.
   The following command screen is displayed:
   
   
2. Enter Remote Location or *IPADDR and From File Name mandatory parameter fields and press F9.
   Note: If a remote location has not been defined, you can still use the command line. When the value for the remote location is set to *IPADDR, an additional parameter field Internet Address is displayed to hold the IP address or an IP name of the remote system as shown below.

   
   
   
3. Enter values in the parameter fields as required. For parameter descriptions, see the Send and Receive File Parameters section.
   Press the Page Down key for the rest of the parameter fields.
   
   Press the Page Down key for the rest of the parameter fields.
   
   Press the Page Down key for the rest of the parameter fields.
   
   Press the Page Down key for the rest of the parameter fields.
   
   Press the Page Down key for the rest of the parameter fields.